Play It


Introduction:

Play It

Build a toy with little difficulty and lots of fun with 75-inch PVC pipes

Total Coust: R$ 214,00

Total Time: about 2 hours


Step 1:

Go Shopping

List of materials:

2 Panneaux MDF

4 PVC Tubes 50 cm

2 PVC Tubes 30 cm

2 PVC Tubes 1,20 m

4 PVC Knee 90°

4 PVC Knee 45°

4 PVC Glove

1 Blue spray paint

1 Green spray paint

1 Yellow spray paint

1 Saw

1 PVC glue

6 Table tennis ball

8 Clamps

(Before starting the assembly, cut the tubes according to the sizes mentioned below and if you prefer, paint the color of preference)

Step 2:

Cut the Tubes According to the Component

Component 1:

- 1,20 m of PVC pipe (1)

- With the help of the glue, fit the tube in the knee of 45°.

Component 2:

- Cut 50 cm of pvc tube (2 and 8)

- Cut 30 cm of all pvc (5)

- Collect in the upper part of the tube 2, the one 45° knee (1)

- Collect in the bottom of the whole 2 a 90° knee (3)

- Then glue a glove (4) to the 90° knee (3)

- Collect the glove (4) to the 90° knee (3)

- Then glue the tube (5) with a 90° knee (6)

- Collect a glove (7) on the knee (6)

- In order to finish put the glove (7) or 50 cm tube (8)

Component 3:

- Cut 1,20m of PVC tube (2)

- Collect a 45° knee (1) on the tube surface (2)

Component 4:

- Cut 50 cm of pvc tube (2 and 7)

- Cut 30 cm of all of pvc (4)

- Collect in the upper part of the tube 2, the one 45° knee (1)

- Collect in the bottom of the whole 2 a 90° knee (3)

- Then glue a glove (4) to the 90° knee (3)

- Then glue the tube 5 to the sleeve (4)

- Collect a glove (6) in the tube (5)

- Collect the knee from 90° (7) to the glove (6)

- In order to finish, stick the tube (8) to the knee (7)

Step 3:

After the Construction of the 4 Components

After the construction of the 4 components:

- Place the two parallel plates apart, where there is a space between them as if there were another plate.

- Put the 4 components between the plates, with the following arrangement: Component 1, 2, 3 and 4, all with the same spacing distance between them and with the same height in relation to the floor.

- To fix the boards mentioned above, use 8 clamps, one for each component on each board, and two for each component.




Comments

Add a Comment

Sign in to comment.